Installation guide - IPad using Airwatch MDM System

How to setup Digiexam

Install the application

1. Click on the "+Add" button in the top-right corner and select "Add new: Public application" (see figure 1)

Figure 1

2. Select the platform Apple iOS and search for Digiexam (see figure 2)

Figure 2

3. Select Digiexam from the list (see figure 3)

Figure 3

4. Set device assignment to the devices you wish to install Digiexam on. In this example, we want to install it to All Devices (see figure 4)

Figure 4

5. Set the deployment Push Mode to Auto if you want the application to be automatically installed (see figure 5)

Figure 5

6. Save and publish the application (see figure 6)

Figure 6

7. Confirm the application publish (see figure 7)

Figure 7

Install the profile
In order to allow Digiexam to use Autonomous Single App Mode, we need to install a profile on the devices that will use the Digiexam app.

1. Click on the "+Add" button in the top-right corner and select "Add new: Profile" (see figure 8)

Figure 8

2. Select Apple iOS (see figure 9)

Figure 9

3. Enter a descriptive name for the profile and what devices that should get the profile. In the example, we chose Digiexam Autonomous Single App Mode as a profile name and we installed it on All Devices (see figure 10)

Figure 10

4. Switch view to "Single app mode" in the right side navigation and press "Configure" (see figure 11)

Figure 11

5. Setup autonomous single app mode to be allowed for se.digiexam.ipad and publish (see figure 12)

Figure 12

6. Confirm the profile publish (see figure 13)

Figure 13

Was this article helpful?
0 out of 0 found this helpful